Flama 1327FL Manuel D'instructions page 30

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MODE button
Press the MODE button once to alternate
between automatic mode and clothes
drying mode; the corresponding indicator
will light up.
Automatic mode
When the ambient humidity ≥ + 3% of the
defined humidity, the fan will start and
the compressor will start after 3 seconds.
When the ambient humidity is ≤ -3% of the
defined humidity, the compressor will stop
working and the fan will stop working after
a delay of 30 seconds.
The fan speed and humidity settings can be
adjusted in automatic mode.
Clothes drying mode
In this mode, the dehumidifier will optimize
the fan speed and dehumidifying capacity
to accelerate clothes drying. The standard
humidity setting is 20% and the fan speed
and humidity settings cannot be adjusted.
TIMER button
Press this button to define the timer function
from 0-24 hours. The increments are of
1 hour. Each time the button is pressed,
the time will increase by 1 hour and the
corresponding time will be displayed on the
screen. The default value of "00" cancels
the timer function. The indicator will turn
off.
After the timer is defined and concluded,
the timer LED will stay lit during that period
of time. After the time is up, the timer LED
will turn off automatically.
While operating, set the time for the
dehumidifier to turn off.
In rest mode, set the time for the humidifier
to turn on.
28
Humidity and timer control buttons
Press these buttons to adjust (increase or
decrease) the humidity and time.
To adjust the humidity, press once to
increase or decrease by 5%.
To adjust the time, press once to increase or
decrease by 1 hour.
LOCK button
Press the button for 3 seconds to activate
the child lock function. The child lock
indicator light will turn on. All buttons will
be locked and non-operational.
Press the button again and the indicator
light will turn off and the button will be
deactivated.
Turning
automatically cancel the child lock function.
Filter REST/RESET button
Press the rest mode button and the indicator
will light up and activate rest mode. Press
the button again to turn off the function.
In rest mode, the fan speed will
automatically change to low and, if no
operation occurs within 10 seconds, except
for the rest mode indicator light turning on,
all the lights will turn off.
When the room humidity is ≤ 57%, the
compressor will stop working and the fan
will stop working 30 seconds later. When
the ambient humidity is ≥ 63%, the fan
will start and the compressor will start 3
seconds later. In this mode, the fan speed
and humidity adjustment functions cannot
be set.
In rest mode, the alarm will not sound
when the water tank is full, but the full
tank indicator light will turn on (red) as a
www.flama.pt
off
the
dehumidifier
will

Publicité

Table des Matières
loading

Produits Connexes pour Flama 1327FL

Table des Matières