Table des Matières
Publicité
Attach Display to Stand
Attach Display to Stand
Attach Display to Stand
Attach Display to Stand
Loosely install ONE (1) "H" screw to the center of each display bracket.
This will act as an alignment screw for the next step.
Two people are needed to install the display on the stand. Position alignment
screw into the "key hole" slot as shown and continue holding display.
XL Electric Lift, Mobile Stand Designed for 85" Surface Hub 2S
www.salamandercommercial.com
501-680/MS [10.22]
page 8 of 24
Publicité
Table des Matières
