Table des Matières
Publicité
display installation
Attach Brackets to Display
Check depth of screw threads in display before inserting screws.
Inserting a screw that is longer than the hole could result in damage
to display. Depth can be confirmed by inserting hex wrench into hole
and marking its length then confirming this length is sufficient by
comparing it to the screw you are using.
Install interface mounting brackets (O) onto display as shown using spacer kit and supplied
Phillips screws (A-G) or screws specified by the display manufacturer. Hand tighten first
to confirm thread and depth match. Note: Affix display brackets "Ears-Out" as shown.
Ears out
XL Electric Lift, Mobile Stand Designed for 85" Surface Hub 2S
www.salamandercommercial.com
501-680/MS [10.22]
page 7 of 24
Publicité
Table des Matières
