Enviro MCT12 Mode D'emploi page 4


Next, we will carry out the connection between the module and the console by means of cables with following
characteristics:
 6-way cable with a 6-way RJ45 connector at each end (to connector A)
 4-way cables with a 4-way RJ45 connector at each end (to connectors B and C)
 8-way cable with a 8-way RJ45 connector at each end (to connector D)

These cables have to be build so that they act transparently as shown in the figure below:

Once the complete installation of one or various chassis and the peripherals connections to ENVIRO has been carried out,
you should adjust the volume of this module so that the
final step in the modules configuration, you may wish to adjust the tone controls.
MCT12 MODULE
MCT12
2/2
Pin number one of both connectors share the same cable
colour, the rest of pins should be paired the same way.
3
SIGNAL LEVEL
LED lights up green while talking normally. As the
4
1
PRIORITIES:
Priority 1: J101-J104
Priority 2: J102-J105
Priority 3: J103-J106
2
50.0035.01.00