GLO HyperX2 Notice D'utilisation page 33

63
03 Turn on
This glo™ tobacco heater has two heating modes:
'STANDARD' and 'BOOST'.
You can choose either a STANDARD or BOOST mode
when you start a session.
Starting a session:
To start a session in the desired mode, press and hold
EN
the appropriate button for 3 seconds, as shown below:
Base Mode
Boost Mode
The device will vibrate to indicate the session start.
The first light on the display will begin to flash as the
start-up is initiated. The device will vibrate once when
in standard mode, and twice when in boost mode.
Standard Mode Start-up
(20 seconds)
Press and
hold Base
button
for 3 seconds
Press and
hold Boost
button
for 3 seconds
The start-up procedure is completed when all lights
on the outside of the display are illuminated. At this
stage the glo™ tobacco heater will vibrate once.
Boost Mode Start-up
(15 seconds)
5 seconds
10 seconds
15 seconds
20 seconds
Ready to use
64
EN
3.2 seconds
6.4 seconds
9.6 seconds
12.8 seconds
Ready to use