Connecting Washer Parts - Wilks USA RX545i Mode D'emploi

RX545i

Connecting washer parts

Fig.1
Fig.3
The washer has a side mounted holster which
holds the gun / lance neatly in place for storage.
This is assembled by sliding the top clasp (fig. 2)
onto the mounting point (fig. 1)
A lower retainer holds the end of the gun / lance
securely. This is attached by sliding the lower
cup (fig. 4) onto the mounting point at the base
of the washer (fig. 3)
A
Fig.5
The front lower handle provides a convenient
point to grip when transporting your washer and
also serves as additional stability when upright.
To attach, insert the handle 'A' into the sockets
'B' at the lower front of the machine. Fix in place
on the under-side with the two screws provided.
4
Fig.2
Fig.4
A
B
B
Fig.6
English
Tips for getting started
Automatic On / Off:
The motor on this pressure washer does not run
continuously. It only runs when the trigger of the
spray gun is squeezed.
Bleeding the gun:
It is very important to bleed the gun before and
after using the pressure washer.
Squeeze the trigger to allow any air that is
trapped inside of the unit and hose to escape.
Continue to squeeze the trigger until a steady
stream of water comes from the nozzle. (This
process may take up to 2 minutes).
This will prevent freezing in cold temperatures
and damage to the machine and the gun.
© Wilks-USA