Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
E
II 3 G Ex mc IIC T4 Gc, II 3 D Ex mc IIIC T135°C Dc
Cert. ARTIDOR 23ATEX9999
TF & Serial No.: AS239999
WARNING
Artidor Explosion Safety B.V., Emopad 38, 5663 PB Geldrop, The Netherlands
Example of an AR-047 signal light label
7.
Installation instructions
•
Installation of explosion-safe equipment such as this product must be carried out by
personnel specially trained and qualified to do this, following the relevant requirements
of the installation standard EN 60079-14.
•
For the installation and use of this product the relevant safety regulations and also the
generally recognized latest state of the technology apply.
•
During assembly, care must be taken that the framework, screws and surface are strong
enough to take the weight of the signal light.
•
Isolate power from the electrical supply cable prior to installation.
•
Mount the signal light on a metal frame connected with ground (equipotential bonding). If
this is not possible, connect an earth wire to the external earth boss and ensure that this
is in sufficient electrical connection with ground.
•
Install the connection cable and make sure that it is protected from mechanical and
chemical influences.
•
Connect the end of the cable in a proper way to an external connection box and ensure
this is done professionally. The connection box is not supplied. Use a connection box
that it is suitably protected for the (explosion hazard) classification of the surroundings in
which it will be used.
•
The 4-wire connection cable has the following connections:
Function
Continuous mode supply voltage (+)
Blinking mode supply voltage (+)
Neutral (-)
Ground
Installation manual AR-047 LED signal light
8 / 36
AR-047 SIGNAL LIGHT
24 VDC, 160 mA
Light color: red
-20 °C < Ta < +60 °C
To avoid electrostatic charge clean only
with a damp cloth. Do not use solvents.
Wire number
1
2
3
Green / Yellow
Year: 2023
01-2023
Publicité
Table des Matières
