Avidsen 123281 Mode D'emploi page 31

Take care not to damage it during removal, as the warranty is voided in the event of damage or a sealing fault.
Tool needed: Thin, magnetic cross-headed screwdriver with PH1 bit holder (Philips).
Carry out the following operations on a flat and well-lit surface.
• Remove the 3 screws from the back of the camera using the screwdriver. Be careful not to lose the 3
O-rings that come with these screws
• Separate the two components, but be careful not to disconnect/rip the cables.
• Remove the 4 black screws (red marking) holding the camera lens in the housing. Always use the
screwdriver for this step
720P WIFI IP CAMERA
C - INSTALLATION
EN
9