Fein KFH17-8 Serie Mode D'emploi page 24

en
24
Symbol, character
(**)
(Ax – Zx)
Character Unit of measurement,
international
n
/min, min
0
r/min
P
W
1
P
W
2
U
V
f
Hz
M...
mm
Ø mm
°
c
max
mm
a
max
mm
R
kg
L
dB
pA
L
dB
wA
L
dB
pCpeak
K...
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 465 06 0). The documents mentioned should
be kept for later use and enclosed with the power tool,
should it be passed on or sold.
Explanation
Copper paste (Cu)
See section "Operating Instructions"
Apply oil
May contain numbers and letters
Marking for internal purposes
Unit of measure-
ment, national
-1
, rpm, rpm
W
W
V
Hz
mm
mm
°
mm
mm
kg
dB
dB
dB
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
min, m/s
Explanation
Rated no-load speed
Power input
Output
Rated voltage
Frequency
Size of metric thread
Diameter of a round part
α =bevel angle (milling head angle)
c (max., 45°)=max. bevel length
a (max., 45°)=max. bevel height (setting
dimension)
R=radius
Weight according to EPTA-Procedure 01
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
2
Vibrational emission value according to
EN 62841 (vector sum of three directions)
Basic and derived units of measurement from the
international system of units SI.
2
Please also observe the relevant national industrial
safety regulations.
Intended use of the power tool:
hand-guided bevel milling machine for professional use
by instructed operating personnel in weather-pro-
tected environments using the application tools and
accessories recommended by FEIN:
– for machining workpieces made of steel, cast steel,
fine-grained steel, stainless steel, aluminium, alumin-
ium alloys, brass and plastic
– for commercial use in industry and trade
– for the preparation of K-, V-, X- and Y-shaped
welding joints
– for machining visible edges in plant, equipment and
general engineering