Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SETUP, OPERATION & PREVENTIVE MAINTENANCE
SETUP
• Prior to each use, visual inspection (See page 6) shall be made to the device by checking for
abnormal conditions, such as cracked welds, leaks, and damaged, loose, or missing parts.
• Consult the vehicle owner's manual to determine the location of lift points.
• Be sure to set the vehicle in park with the emergency brake on and wheels securely chocked.
• Be sure that the vehicle and the jack are on a hard, level surface.
ASSEMBLY
• If two piece handles are provided, assemble the upper section into the lower section, line up
the holes, insert and tighten the screw.
• Insert the bottom end of handle into handle fork and securely tighten the bolt and washer.
Ensure the handle can turn freely
LIFTING
• Turn the handle/release valve clockwise to the closed position. Do not over tighten.
• Position the jack under the specified lift point.
• Begin lifting by pumping the handle up and down.
• Immediately after lifting, support the vehicle with appropriately rated jack stands.
• Turn the handle/release valve slowly counterclockwise to lower the vehicle onto jack stands.
LOWERING
• Turn the handle/release valve clockwise to the closed position. Do not over tighten.
• Pump the handle up and down to lift vehicle o jack stands.
• Remove the jack stands. Do not get under or let anyone get under the vehicle while lowering.
• Turn the handle/release valve slowly counterclockwise to lower the vehicle onto the ground.
• Never turn the release valve more than one half of a turn as this will cause a rapid drop rate
which could lead to injury and/or property damage.
• After safely removed from load, ensure the ram and the handle sleeve are both fully in the
down position to reduce exposure to rust and containments
3
USER MANUAL
Publicité
Table des Matières
