Assembly Storage Net - Extremis CAPTAIN'S CHAIR Mode D'emploi

ASSEMBLY STORAGE NET

WHAT YOU NEED
1 person
scissors
+/- 10 min.
3. Pass the elastic once again
through the first hole, upward
from below.
6. Tie a double knot in the elastic
and trim off any excess.
10 assembly storage net + maintenance
1. Pass the elastic through the first
hole. Make sure that the knot is
located on the underside of the
storage net.
4. Then wind the elastic around the
frame's horizontal element
(downward from above) and pass
it through the next hole. Proceed
in the same way until you reach
the last hole.
7. Repeat these steps on the other
side.
2. Then wind the elastic around the
outer vertical element of the
frame and under horizontal
element.
5. When you have passed the elastic
through the last hole, wind it around
the outer vertical elemenet of the
frame, then under the horizontal
element and pass it once again
through the last hole downward
from above.