Safety Tips - Kraftixx 0624-90 Mode D'emploi

-
Instructions for use
b
d
a) On / off switch
b) Spirit levels
c) Battery compartment
d) Laser beam output
Important: please read these operating instructions carefully before
using the product.
The Line Laser enables the projection of a continuous laser
line in place of dots. The line laser is excellently suited for the projection
of markings on a variety of surfaces. The ideal aid for tiling work,
laying laminates and so on.
Operating instructions
Switch on the laser by pressing the switch (a). Press switch (a) again
to switch it off. The laser will then project a continuous line.
Changing the battery
To change the battery, open the battery compartment (c) on the bottom
of the device. Dead batteries must be disposed of properly.
-Art.: 0624-90
c

Safety tips:

• Never look directly into the laser beam. The beam
can permanently damage your eyes. Do not aim
at persons or reflecting surfaces with the laser beam.
• Keep the work area clean and orderly. Avoid any blows
or knocks to the unit.
• Never expose the line laser to moisture or rain.
• Store the line laser in a dry safe place.
• If the line laser is not to be used for a prolonged
period of time, remove the batteries, in order to prevent
damage caused by leaking batteries.
• Check the line laser and all components for damage
before use. Only use the unit if all parts are in good
condition.
• Repairs may only be performed by specialised
personnel.
• Only use the line laser for the measuring tasks
indicated in these instructions.
a
• Only use accessories which are specifically
recommended for the use of the line laser
• Any manipulation leading to an increased laser
performance is forbidden. We do not assume any
liability for damage incurred due to a non-compliance
with these notes on safety.
• The laser pointer does not include any service parts.
For that reason, please do not open the housing as
otherwise we no longer assume any warranty for the
product.
• Keep out of reach of children
geprüfte
Sicherh eit
• Principally, measurements taken with the Line
Laser must be verified. We assume no liability for
measuring errors and any resulting damage
arising thereof.
Technical Data:
Wavelength: 650nm
Power supply: 2 x 1.5 V AAA batteries
Maximum energy output: 1mw
Laser beam,
do not look into
STATEMENT OF CONFORMANCE
On its own responsibility, kwb-Karl W. Burmeister GmbH & Co. KG hereby
represents that the line laser referred to in this statement conforms to both
the standards listed below: EN 60825-1:1994 + A2 : 2001+ A1: 2002, EN
61010-1:2001, EN 50081-1/1992, EN 50082-1/1997 and the specifications
set forth in Guideline EMC 89/336/EWG.
k Karl W. Burmeister GmbH & Co. KG
Gewerbegebiet Seckenhausen-West 28816 Stuhr
k Produktentwicklung
Laser class 2 pursuant to
EN 60825-1:1994 +
beam
A2:2001+A1:2002
WARNING!
Electrical devices should never be
discarded with household garbage. Please bring
these to the appropriate collection center.
12.06/B