Table des Matières
Publicité
BOOST-R-BOTS
How to Use the Remote Control
Remote Control Configuration
Remote Control ID Check/LED Status
RemoteCon ID status display. (1~8 LED)
ID Settings button
Forward/Backward
button
Setting Remote Control ID
① Turn on the robot.
② Select mode # 2 mode.
③ Press
button while holding
④ Press
button while holding
⑤ After selecting ID, if you release
⑥ The LED on the mainboard will blink 3 times and it will turn off automatically.
That means the ID Selection is finished.
⑦ If you press
※ If there is a problem, repeat steps 1-7 carefully.
How to Set Up Communication ID
※ The maximum number of channels can be set as shown below without interference.
Use the picture to assign the channels to the communication ID.
CH 1
42
38
™
BOOST-R-BOTS
Special Function keys
button. The
button and choose your ID. (Number 1~8)
button and press
button, you can see your selected ID.
CH 2
CH 3
Remote Control ID Check LED
Once the ID setting is finished,
the "OK" LED turns on.
A
panel ID LED turns on and shows you the chosen mode.
button, ID will be selected.
CH 4
CH 5
CH 6
ID Check button
Left/Right button
A
CH 7
CH 8
Publicité
Table des Matières
