Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
treatment can damage the unit, and may
create a hazardous condition or void the
warranty.
FUEL TYPE
The Dragon is designed to operate on
diesel fuel. In cold weather, add 4 oz.
Diesel Guard™ for each tank of fuel. See
"Cold weather recommendations" below.
WARNING: Failure to use diesel fuel
as specified could cause injury and
permanent damage to the unit. It may
also void the Dri-Eaz warranty.
For best results, purchase fresh fuel from
a reliable fuel distributor. Keep the
Dragon fuel tank full to help prevent the
formation of condensation inside the tank.
When not using the Dragon for extended periods of
time, we recommend the addition of Diesel Guard fuel
stabilizer as described below.
Cold weather recommendations
To optimize fuel quality and improve performance in
cold condtions use 4 oz. Diesel Guard anti-gel deicer
additive in each full tank of fuel. This product helps to
prevent fuel gelling and freezing problems in cold
conditions. The treatment also has anti-corrosion
properties and provides additional lubricity, while
detergents help to keep the burner nozzles clean and
operating efficiently. Follow lable instructions for
proper use. Additional quantities of Diesel Guard may
be purchased from your Dri-Eaz distributor.
Increasing temperature rise
In normal operating conditions (above 35°F / 2°C), the
weather shield can be removed when operating the
Dragon. However, when operating the Dragon in
extremely low outdoor temperatures (below
35°F / 2°C) the temperature of the heated air can be
increased by leaving the weather shield in place during
operation. Note that removing the weather shield
increases airflow by about 100 CFM but will reduce the
Dragon's heat output.
BEFORE FIRST USE
The unit is shipped with an Accessory Kit that includes
the following 1) Heat outlet duct ring, 2) 25 ft. / 7.6 m
of heat resistant semi-rigid ducting, 3) a handle and 2
locking clevis pins, 4) weather shield, and 5) exhaust
stack and rain cap. A heat sensor cable is permanently
attached to the unit and is ready for use.
49-120C 2015-01 Warranty 07-00424
Fig. B: Weather Shield and Handle Installation
Place lower brackets over
posts and then lower over
upper posts.
Slide handle into slots
and secure with clevis
pins provided.
Install Handle
Insert handle into slots on the sides of the fuel tank.
Insert clevis pins on both sides and secure with clip.
See Fig. B.
Install Heat Outlet Duct Ring
Install on the heat outlet using the 8 screws provided.
Install Weather Shield
Place shield over lower posts first, then lower into
place over the the two upper pegs. See Fig. B.
Setting up the Dragon
Choosing a location
WARNING! Use the Dragon outdoors only. Place
the unit on a level, stable surface. Be sure to
chock the wheels securely to prevent the unit from
rolling. Choose a location away from high-traffic
areas, children and pets, and ensure there are no
obstructions to the air intake.
NOTICE: Keep air intake vents clean and clear of any
obstruction. Avoid setting up unit in a location where
the intake could be blocked or restricted. Blocking the
air intake will cause the unit to produce sooty exhaust,
potentially damaging the unit and the structure being
heated.
NOTICE: Install and operate the Dragon in
accordance with all local and regional regulations.
Fill the fuel tank
The Dragon is shipped with the fuel tank empty.
Before operating, fill the tank with diesel. Do not
overfill.
3
Dri-Eaz Products, Inc.
Publicité
Table des Matières
