TAD M700 Mode D'emploi page 13

BI-wire connection
The bi-wire connection uses two speaker cables on one amplifier to connect to the speaker's low-frequency input
terminal and high-frequency input terminal.
In order to connect speakers to this unit using a bi-wire connection, the speakers must be bi-wiring compliant. Align the
High and Low wires correctly to connect.
[An example of connections made to a speaker system with bi-wire connection terminals]
TAD-M700
To balance output terminal
TAD-M700
−
Rear side of bi-wiring
compliant speakers
Note
SPEAKERS A terminals and SPEAKERS B terminals produce the same output. High and Low connectors can be made
to either terminals A or B.
CAUTION
 When using bi-wire connections, make sure to remove the short bar connectors on the High-Low terminals of the
speakers to prevent negative effects on the amplifier. Refer to the operating instructions of your speaker system for
further information.
Pre-Amplifier
R
+
High
Low
To balance output terminal
L
TAD-M700
+
−
High
Low
Rear side of bi-wiring
compliant speakers
TAD-M700 / TAD-M700S
13