Publicité
Operating Instructions
Installation
Operation
Caution
Trouble Shooting Aurora Paper Shredders
Maintenance
Limited Warranty
Manuel de fonctionnement
Installation
Fonctionnement
Avertissement
Dépannage des déchiquteuses
à papier Aurora
Entretien
Garantie limitée
Instrucciones para operar
Instalaciones
Operación
Avertencia
Solucionar Problemas de la Máquina
Trituradora de Documentos Aurora
Mantenimiento
Garantía Limitada
Please read these operating instructions before using the unit.
Customer Service: 1 - 800 - 327 - 8508 or INFO@AURORACORP.COM
Avant d'utiliser cet appareil, Veuillez lire toutes les instructions.
Service à la clientèle : 1 - 800 - 327 - 8508 OU INFO@AURORACORP.COM
Antes de operar esta unida, por favor lea todas las instrucciones.
Servicio al Consumidor: 1 - 800 - 327 - 8508 O INFO@AURORACORP.COM
1
12 sheets of
Sheet Capacity
20lb. bond paper
Credit Card & CD Capacity
1 at a time
3/16" x 2 5/32" pieces
Paper Shred Size
0.48 cm x 5.50 cm pieces
Voltage
120V-60Hz 3.5A
Capacité de passage
12 feuilles de papier
à la fois
bond de 75g/m2 (20lb.)
Capacité de CD et
les introduire un par un
les cartes de crédit
en morceaux de 3/16" x 2 5/32"
Dimensions des déchets
en morceaux de 0.48 cm x 5.50 cm
Tension
120V-60Hz 3.5A
Capacidad de
12 hojas de papel de
destruccióna la vez
cartes de 20 libras
Capacidad de CDs y
introdúzcalos en la ranura
tarjetas de crédito
uno por uno
en pedazos de 3/16" x 2 5/32"
Tomaño de corte
en pedazos de 0.48 cm x 5.50 cm
Voltaje
120V-60Hz 3.5A
( U.S.A. ONLY )
( ETATS-UNIS SEULEMENT )
( LOS ESTADOS UNIDOS SÓLO )
INSTALLATION :
Carefully assemble the paper shredder by following the Assembly Guide closely. (FIGURE 1)
Align wastebasket properly with the rails and slide in to complete assembly. (FIGURE 2)
Failure to follow assembly instructions may result in paper shredder not functioning properly.
Connect the power cord to any standard 120 volt AC outlet.
Caution: Crosscut shredders have very sharp, exposed blades on the underside.
Use care when mounting the shredder on the wastebasket.
FIGURE 1
OPERATION :
Using the switch located on the unit, select one of the following settings by sliding the switch either
left or right (FIGURE 3).
I
Auto: This setting allows the shredder to be automatically started by inserting paper into the
shred opening. Always feed the paper in as straight as possible. When the paper has
passed through, the shredder will stop. (FIGURE 3)
O
Off: This setting turns off all features of the shredder. For safety reasons, we recommend that
you leave the shredder in the Off position whenever the shredder is unattended or not in use.
(FIGURE 3)
R
Rev: In the unlikely event of a paper jam, the reverse setting can be used to help clear the
cutters of paper that has not passed through. Never attempt to clear a jam by using
the reverse function until you have emptied the wastebasket. (FIGURE 3)
Never shred plastic (except credit cards and only by inserting them, one at a time,
through the special credit card slot), continuous forms, anything with adhesive including
labels and envelopes, newsprint, or any hard materials. While this shredder will shred
staples and small paperclips, it is recommended that you remove them whenever
possible in order to extend the life of your shredder.
FIGURE 2
FIGURE 3
continued on next page
2
Publicité
