Assembly
Base
Base
1
•
Fit the tabs on the tower into the slots in the
base. Push to "snap" the tower in place.
•
Insérer les languettes de la tour dans les
fentes de la base. Appuyer pour emboîter
la tour.
Assemblage
Tower
Tour
Upper Ramp
Rampe supérieure
2
•
Fit the tabs on the upper ramp into the slots
in the lower ramp.
•
Insert two screws into the upper ramp.
Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
•
Repeat this procedure to assemble the other
upper and lower ramps.
•
Insérer les languettes de la rampe supérieure
dans les fentes de la rampe inférieure.
•
Insérer deux vis dans la rampe supérieure.
Serrer les vis avec un tournevis cruciforme.
Ne pas trop serrer.
•
Répéter ce procédé pour assembler l'autre
rampe supérieure à l'autre rampe inférieure.
3
Lower Ramp
Rampe inférieure