Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Additional Options
Field-Adjusting Regress Depth
1.
Using a #1 Phillips screwdriver, remove the set screws in the regress (see fig. 17).
fig. 17
2.
Adjust the regress depth using the indicators (see fig. 18).
Note: Indicators are opposite the flexible conduit.
Depths: 0 in (0 mm), 0.5 in (12.7 mm), 1 in (25.4 mm), 2 in (50.8 mm).
fig. 18
3.
Reattach the Phillips set screws (see fig. 19).
Note: Confirm the regress is aligned at a 90˚ angle (see fig. 20).
fig. 19
4.
Insert the light engine and turn clockwise to lock.
Note: Confirm the light engine is centered in the housing. If it is not centered, adjust the regress
alignment to 90˚.
5.
Re-insert Baffle.
12 | D4R INSTALLATION GUIDE
fig. 20
P/N 3662345 Rev B
© 2019 Ketra, Inc. All rights reserved.
Publicité
Table des Matières
