Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Figure 2
Extension
Transmitter
Microphone
3. Note: The transmitter can be oriented horizontally or vertically. Temporarily
place the Extension Transmitter in the intended mounting position. Press the
Test Button. If the plug-in chime sounds, continue with step 4. If the plug-in
chime does not sound, go to the Troubleshooting section before continuing
with step 4.
4. With the Extension Transmitter still in the intended location, activate the exist-
ing door chime. If the plug-in chime sounds, proceed to step 7. If it does not
sound, try different positions for the transmitter, or increase the microphone
sensitivity (Figure 3) by turning the Microphone Sensitivity Adjustment
clockwise. In some instances, it may be necessary to take the removable
microphone out of the transmitter case, and mount it directly on the exist-
ing chime case or inside the existing chime case on a resonating chamber
(not on chime bars). Please note–the microphone wires can be temporarily
removed from the wire terminals (Figure 3) by loosening the terminals with
a phillips screwdriver if wire routing through small openings in the existing
chime cover is desired. There is a slot on the transmitter cover for the wires
if an external mounting is required. Double-sided tape is provided to attach
the microphone to your existing chime case.
3.
1. Remove the battery cover from the Extension Trans-
mitter by pressing on the cover with your thumb, then
slide the cover off as shown Figure 2.
2. Install four AAA batteries (not provided). Make sure
batteries are oriented properly (see page 5).
Microphone Wire
Terminals
Figure 3
Install the Extension Transmitter.
Microphone Sensitivity
-2-
Adjustment
Test Button
Transmit
Light
Existing
Doorbell
595-5345-07
Publicité
Table des Matières
