Fellowes Powershred 125Ci Mode D'emploi page 3

Masquer les pouces Voir aussi pour Powershred 125Ci:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A.
B.
C.
D.
CAPABILITIES
Will shred: Paper, credit cards, CD/DVD, staples, small paper clips and junk mail
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper,
cardboard, large paper clips, folders, X-rays or plastic other than noted above
Paper shred size:
Cross-Cut (125Ci) ..................................5/32 inches x 1-1/2 inches (4mm x 38mm)
Strip Cut (125i) ........................................................................ 7/32 inches (5.8mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
the instruction manual. Read the entire instruction manual before
operating shredders.
entry. Always set to off or unplug when not in use.
from shredder openings. If object enters top opening, switch to
Reverse (
flammable products on or near shredder. Do not use canned air
on shredder.
Do not place near or over heat source or water.
2
F.
G.
H.
KEY
A. SafeSense
B. Paper entry
C. CD/Credit card safety flap
D. Door
F. Disconnect power switch
I.
G. See safety instructions
) to back out object.
H.
®
1. Reverse
3. Forward
4. Auto
6. Door open (red)
7. Bin full (red)
8. Remove paper (red)
9. SafeSense
Maximum:
Sheets per pass (Cross-Cut) ..................................................................................20*
Sheets per pass (Strip Cut) ...................................................................................18*
CDs/Cards per pass ................................................................................................1*
Paper entry width ......................................................................... 9 inches (230mm)
*8.5"x11", 20lb., (75g) paper at 120V, 60 Hz, 125Ci 9Amps, 125i 6Amps; heavier
paper, humidity or other than rated voltage may reduce capacity. Recommended
daily usage rates: 3300 (125Ci) 3000/(125i) sheets per day; 100 cards; 10 CDs.
Fellowes SafeSense
®
shredders are designed to be operated in office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
converters, transformers, or extension cords should not be used with
this product.
Models 125Ci/125i
I. Casters (2)
indicator (yellow)
®
ENGLISH

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Powershred 125i

Table des Matières