Care & Cleaning - Back to Basics AutoServe SR1000 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CARE & CLEANING
Before using the first time and after each use, be sure to thoroughly wash the
mixing container, blade assembly, rubber gasket, valve, lid and stir stick. To
prolong the life of your smoothie maker,
Unscrew and disassemble the valve for cleaning (see below). Also, remove
blade assembly from the mixing container and rubber gasket for cleaning; turn it
clockwise to remove.
CLEANING THE DISPENSING VALVE
To disassemble dispensing valve for cleaning:
1. Remove the valve from the container by unscrewing the entire valve counter-
clockwise.
2. Remove the cap from the valve body by rotating the lever upwards from the
back of the valve body to a position above the cap. Then unscrew the cap by
rotating it counter-clockwise.
3. Squeeze cap and stopper together and slide the lever off the stopper pin.
4. Remove the stopper and stopper pin by pulling the rubber rim of the stopper.
The stopper and pin are tightly fit and need not be separated.
5. Remove the spring.
6. Clean all parts in warm soapy water, allow to dry thoroughly and reassemble
in the order shown.
in the order shown.
Lever
CLEANING
smoothie maker do not wash parts in the dishwasher.
smoothie maker,
Cap
Spring
Stopper Pin
Stopper
Valve Body
11

Publicité

Table des Matières
loading

Table des Matières