Saba LVS14C45MI17GLB Mode D'emploi page 49

Change the Program
Premise:
1. A cycle that is underway can only be modified if it has only
been running for a short time. Otherwise, the detergent may
have already been released, and the appliance may have
already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see
the section entitled "Loading the Detergent").
2. Open the door, the machine will be in standby state, press
GB
the program button more than 3s then you can change the
program to the desired cycle setting (see the section entitled
"Starting a wash cycle...").
The front indicator shows the state of dishwasher:
A. blue light with blinking: running;
B. blue light without blinking: pause;
C. white light: end of process (open the door, the white light will
extinguish);
D. no light: stand by
NOTE: If you open the door during a wash cycle, the
machine will pause. The program light will stop blinking and
the buzzer will mooing every minute unless you close the door.
After you close the door, the machine will keep on working after
10 seconds.
94
Forgot to Add a Dish?
A forgotten dish can be added any time before the detergent cup
opens.
1. Open the door slightly
2. After the spray arms stop working, you can open the door
completely.
3. Add forgotten dishes.
4. Close the door, the dishwasher will run after about 10
seconds.
At the end of the Wash Cycle
When the working cycle has finished, the buzzer of the
dishwasher will sound for 8 seconds, then stop. Turn off the
appliance using the Power switch button, shut off the water
supply and open the door of the dishwasher. Wait for a few
minutes before unloading the dishwasher to avoid handling the
dishes and utensils while they are still hot and more susceptible
to breakage. They will also dry better.
• Switch Off the Dishwasher
Front indicator shows white light, only in this case the
programme has ended.
1. Open the door, switch off the dishwasher by pressing the
Power button.
2. Turn off the water tap!
• Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be
allowed to cool down around 15 minutes before removing from
the appliance.
GB
95