Navitel E700 TMC Mode D'emploi page 10

Using Device in Vehicle
Windscreen holder
Carefully select a place to attach the holder. Do not attach the
holder to the windscreen in a way that limits the driver's line of
sight. If the car windscreen contains a built-in heating system
or UV protection, the quality of signal reception may be lower
than usual.
Set-up of windscreen holder
First remove the protective layer from the vacuum cup. Then,
select an appropriate place to attach the holder. Make sure
the area is clear of dust, dirt, and moisture, and then secure
the vacuum cup on the windscreen. Under normal operating
conditions, the vacuum cup holder locks the device well.
However, if you leave it there overnight, the holding strength
may get weaker as a result of moisture condensation due to
temperature fall. For this reason, in order to prevent the device
and holder from being damaged, it is recommended to remove
the device and holder from the windscreen.
Navitel Navigator
Navitel Navigator is an offline multifunctional navigation
application used for efficient route search and planning. Key
tasks of the program are identification and display of current
position on the map, automatic and manual setting of route
points, object search, calculation, display of travel information,
and many other things.
Press to open address search and program settings.
USING DEVICE — NAVITEL E700 TMC
Traffic Message Channel (TMC)
TMC is a technology for providing traffic and travel information
carried via FM-RDS radio. This traffic information can be used
for the route planning and find alternate routes.
Car charger with TMC traffic receiver and antenna must be
connected for the TMC operation. Position the PND on the
windscreen and fixing the antenna at the area of stable
reception of the radio stations signal. Don't bend/twist the
antenna or hide it behind the interior elements. It will degrade
the reception quality of the TMC signal.
Full information about TMC coverage is available on the website
www.navitel.cz
| 9
EN