Cleaning And Maintenance - cecotec Cumbia POWER ESPRESSO 20 Manuel D'instructions

ENGLISH
shape of the water outlet. Turn it counter clockwise until the handle is aligned with the "lock"
mark on the appliance. Make sure the steam extraction knob is off.
Pour out hot water in the cup and place the hot cup on the removable grid.
Once the indicator light stops blinking, press the coffee button and coffee will start flowing
into the cup. Press the button again to stop brewing coffee once you have the desired amount
of drink.
Warning: Do not leave the coffee maker unattended while in use, as you need to stop it
manually.
When coffee is ready, remove the portafilter by turning it clockwise. Throw away the
coffee rests by pressing the filter with the filter fastener and turning it upside down over an
appropriate container.
Let all parts cool down and rinse them with water.
How to froth milk
Prepare an espresso as indicated in the previous section; make sure that the steam extraction
knob is off.
Press the steam button and wait until the light indicator stops blinking.
Fill a jug with about 100 ml of milk for each cappuccino you want to prepare. It is recommended
to use cold whole milk for optimal results.
Note: Use a jug with a diameter greater than 70±5 mm, and bear in mind milk doubles its
volume during this process, make sure the jug is high enough.
Turn the steam extraction knob slowly counterclockwise. Steam will come out from the steam
exit.
Note: Do not turn the steam knob quickly, as a great amount of steam could accumulate in a
short period of time and could be dangerous.
Insert about two centimetres of the steam tube into the milk. Froth milk by moving the jug up
and down.
When finished, turn the steam knob to the off position and press the steam button again to
deactivate the function.
Warning: Clean the steam exit with a wet sponge immediately after use. Then, remove the
steam tube and clean the duct's inside part. It is also recommended to emit steam again in
order to clean possible milk remaining inside the tube.
Pour frothed milk into the espresso to prepare cappuccino.
Note: It is recommended to allow the appliance to cool down for at least 5 minutes before
brewing coffee again. Otherwise, your espresso might have a light burnt odour.
How to prepare hot water
Press the coffee button and make sure the steam knob is off. The indicator light will stop
blinking once the appliance reaches the desired temperature.
Turn the steam extraction knob counterclockwise (at least 135º). Then, press the coffee button.
Hot water will flow out from the steam exit.
40
How to heat drinks with steam
The steam exit (without the steam tube) can be used to heat beverages like hot chocolate,
water, or tea.
Remove the detachable tank, open the tank cover, and fill it with water. The water level should
not exceed the "MAX" mark in the tank. Install the tank back in the appliance.
Connect the coffee machine to a power supply. Make sure the steam extraction knob is off.
Press the steam button and the light indicator will start blinking. Wait until the light stops
blinking.
Remove the steam tube from the steam exit.
Introduce the steam exit in the drink you wish to heat. Slowly turn the steam knob
counterclockwise to release steam.
When the required temperature is reached, turn the steam knob to the off position.
Press the steam button again to turn the appliance off.

4. CLEANING AND MAINTENANCE

Turn off, unplug the appliance, and let it cool down before cleaning it.
Clean the housing of the appliance with a wet cloth. Empty the water tank and drip tray, and
clean them together with the removable grid. Dry them thoroughly.
Note: Do not clean the appliance with alcohol or solvents. Do not immerse the main body of
the appliance in water.
Clean the portafilter and the stainless-steel filter under running water.
Mineral deposits cleaning
Clean the mineral deposits every 2-3 months in order to ensure that the coffee maker operates
properly, that the internal piping is clean, and that the flavour of the coffee is good.
Fill the tank with water and descaling liquid up to the "MAX" level (the proportion of water
and descaling liquid is 4:1). Citric acid can also be used (available in chemist's or drug stores)
instead of descaling liquid (100 parts of water and 3 parts of citric acid).
Insert the stainless-steel filter into the filter holder without ground coffee in it and attach it to
the main body as indicated in previous sections. Place a jug under the filter holder. Make sure
the steam extraction knob is off.
Press the coffee button and wait until the indicator light stops blinking. Then, press the coffee
button and dispense about 500 ml (20 fl. oz.) of liquid. Press the coffee button again to stop
and wait for 5 seconds.
Press the steam button and wait until the light indicator stops blinking. Turn the steam knob
counterclockwise to release steam for 2 minutes. Then, turn the steam knob to the off position
and press the steam button again to stop. Allow the appliance to cool down for 15 minutes.
Restart the unit and repeat steps of 4 and 5 at least 3 times.
Press the coffee button and wait until the indicator light stops blinking. Then, press the coffee
ENGLISH
POWER ESPRESSO 20 41