Publicité
INSTRUCTIONS CONTINUED.....
Refrigerated Cooler side:
Carefully lift and tip the shroud/basin
assembly off of the cooler frame.
Only disconnect the (2) black wires
coming from the shroud assembly that
go to the solenoid valve and to the cold
control.
Disconnect the water line at the solenoid
valve. Reference (Fig. 15, Pg.19) for the
operation of the quick connect fi ttings.
Non-Refrigerated Cooler side:
Carefully tip the shroud/basin assembly
toward the cooler frame.
Connect one of the black wires to the
solenoid valve and one to the power
cord.
Re-connect the water line at the
solenoid. Reference (Fig. 15, Pg.19)
for the operation of the quick connect
fi ttings.
Precautions need to be taken when
replacing the Basin/shroud assembly:
1) Make sure all wires are inside
frames so as not to become pinched.
2) Water line coming from bottle fi llter
drain must be pulled down as not to
interfere with the fan operation. The
fan blade needs to spin freely.
.
EZOTL8WS*1A LZOTL8WS*1A
Swap drain parts in shroud:
Loosen each hose clamp retaining
the drain pieces.
Remove each drain piece and swap
to other basin.
Tighten each hose clamp.
Using a #T20 (6 point star bit),
tighten the shroud screws.
Both sides, both coolers, being
careful not to overtighten.
Page 15
INSTALL WRAPPERS &
TRIM STRIPS PER PAGE 11
SEE PAGES 16 & 17 FOR
PLUMBING DIAGRAMS
1000005926 (Rev. B - 01/21)
Publicité
