FACTO 79275031 Guide De L'utilisateur page 5

Step 9:
Insert the U-shaped side canopy braces (#10)
into the canopy frame connectors (#21) and
secure with screws (#22). Make sure that the
teeth of the canopy frame connectors are facing
towards the inside.
See Fig. E – Step 1 and Step 2.
Step 10:
Insert the front and rear canopy braces (#9) into
the sleeves of the canopy (#29).
See Fig. E – Step 3.
Step 11:
Insert the front/rear canopy brace (#9) ends into
the U-shaped side canopy braces (#10).
See Fig. E – Step 4.
Step 12:
Insert the four corners of the U-shaped side
canopy braces (#10) into the pockets of the
canopy (#29). See Fig. E – Step 5.
Step 13:
Fasten the canopy/frame connectors (#21)
on the canopy assembly to the adjustable
teeth on the top cross beam w/adjustable
teeth (#1) by using plastic screws (#20). Do
this procedure for both sides. See Fig. F.
Step 14:
Re-check and re-tighten all nuts and bolts to
ensure swing stability.
Step 1
Step 3
Step 4
Step 5
Fig. E
Fig. F
PAGE 5
Step 2