FACTO 79275031 Guide De L'utilisateur page 4

Step 6:
Open the seat assembly (#7). Fasten the front
end of the swing arm (#6) to the seat assembly
(#7) by using bolts (#17), washers (#23), and
plastic nuts (#13). Then, attach one swing arm
tube (#8) and swing arm (#6) to the seat
assembly back frame by using bolts (#18),
washers (#24), and plastic nuts (#12). Fasten
another swing arm tube (#8) to the swing arm
(#6) at the bend by using bolts (#15), washers
(#24), and plastic nuts (#12). See Fig. B.
Step 7:
Hook the S hook (#11) to the top of both swing
arm tubes (#8). Do the same procedure for both
sides. See Fig. C.
Step 8:
Hang the opposite ends of the S hook
(#11) into the holes located on the angled
braces of the top cross beam w/adjustable teeth
(#1). Do the same procedure for both sides.
See Fig. D.
Warning:
Make sure that both ends of the S hook (#11)
go completely through the holes on the top
cross beam w/adjustable teeth (#1) and the
swing arm tubes (#8).
Fig. B
Fig. C
Fig. D
PAGE 4