Led Indicators; Indicateurs Del; Led-Anzeigen; Indicadores Led - QSC Audio PowerLight Série Manuel De L'utilisateur

Masquer les pouces Voir aussi pour PowerLight Série:
Table des Matières

Publicité

LED indicators

Indicateurs DEL

The red "PROTECT" LED glows when
La DEL rouge "PROTECT" s'allume
the amplifier goes into protect mode.
quand l'amplificateur passe en mode
protection.
The yellow "STANDBY" LED lights
La DEL jaune "STANDBY" ne
only when the amplifier is in standby
s'allume que lorsque l'amplificateur
mode.
est en mode attente.
The green "POWER" LED indicates
La DEL verte "POWER" indique que
that the amplifier is operating.
l'amplificateur est sous tension.
• This red LED lights when the
• Cette DEL rouge s'allume pour
channel clips.
indiquer l'écrêtement du signal.
• These yellow LEDs light at 10 and
• Ces DELs jaunes s'allument à 10
20 dB below the channel's
et 20 dB sous le niveau de
maximum rated output power.
puissance maximale du canal.
• This green LED lights at about 30
• Cette DEL verte s'allume à 30 dB
dB below maximum rated output
sous le niveau de puissance
power.
maximale du canal.
NOTE: Brief, occasional
NOTE: Il se peut que
clipping may be inaudible; this
d'écrêtement occasionel est
is normal and acceptable. If
inaudible; ça c'est normal et
the red "CLIP" LED glows often
acceptable. Si la DEL "CLIP"
and continuously, reduce the
allume souvent ou sans
signal level.
interruption, réduire le niveau
de signal.

LED-Anzeigen

Indicadores LED

Aktivierung der Schutzschaltungen
El indicador LED rojo de "PROTECT"
wird durch die rote „PROTECT"- LED
se enciende cuando se activan las
angezeigt.
protecciones.
Die gelbe „STANDBY"-LED leuchtet
El indicador LED amarillo de
nur im Standby-Betrieb.
"STANDBY" se enciende cuando el
amplificador está en modo
"standby."
Die grüne „POWER"-LED ist die
El indicador LED verde de "POWER"
Betriebsanzeige.
se enciende cuando se el
amplificador está funcionando.
• Diese rote LED leuchtet bei
• Este indicador LED rojo se
Übersteuerung.
enciende cuando el canal está
recortando.
• Diese gelben LED's leuchten bei
• Este indicadores LED amarillo se
10 und 20 dB unterhalb der
encienden a 10 y 20 dB por
maximalen Ausgangsleistung.
debajo de la potencia máxima de
los canales.
• Diese grüne LED leuchtet bei
• Este indicador LED verde se
etwa 30 dB unterhalb der
enciende a 30 dB por debajo de
maximalen Ausgangsleistung.
la potencia máxima de los
canales.
ANMERKUNG: Gelegentliche
NOTA: Es posible y aceptable
Übersteuerung ist oft
que recorte brevemente en
unhörbar; das ist normal und
ocasiones es inaudible. Si el
akzeptabel. Falls die „CLIP"-
indicador LED de recorte
LED oft aufleuchtet oder sogar
("CLIP") se enciende con
dauerhaft, bitte den Pegel
frecuencia y de forma
zurücknehmen.
continuada, reduzca el nivel
de señal.
15

Publicité

Table des Matières
loading

Table des Matières