3.3 Hearth and Mantel Clearances
The following drawings show the hearth and mantel clearances
allowed for the BHM-52 and CLW-72 with no surround or optional
surrounds installed (if applicable). Follow the drawings for the
minimum distance needed between the hearth and mantel to allow
for proper servicing clearances.
3.3.1 CLW-72 Finishing Guidelines
for Optional Surrounds
•
Figure 3.8 shows where to end finishing materials, when
measuring from the finishing edge, to allow installation of any
SURROUND EDGE
FINISHING TRIM EDGE
Figure 3.8, CLW-72 Finishing Guidelines for Optional Surrounds
NON COMBUSTIBLE ZONE
Figure 3.9, CLW-72 Hearth and Mantel Clearances for No Surround
Komfort Zone Kit #KZK-1510 R.5
B
CLW-72
NO SURROUND
COMBUSTIBLE WALL FINISH
MAY BE INSTALLED OVER CEMENT
BOARD AND BUTT UP TO THE
FINISHING EDGE AROUND THE OPENING
EACH SQUARE REPRESENTS 1"
(25mm) OF MANTEL PROJECTION
Non-combustible
material only
12" (305mm)
9" (229mm)
TOPFINISHING EDGE
⁄
28
"
(715mm)
BOTTOM FINISHING EDGE
14" (356mm)
½
17" (432mm)
9
"
(248mm)
20" (508mm)
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
optional surround. Most finishing material will not fit behind the
optional surround(s) when it is installed.
•
Measurement 'A' shows the space to leave on each side.
•
Measurement 'B' shows the space to leave on the top and the
bottom.
Surround
CW72-RS
CW72-RS4
A
CW72-GS
CW72-MS
6" (152mm)
⁄
18
"
(467mm)
A
B
3/4" (19mm)
3/4" (19mm)
2-5/8" (66mm)
2-5/8" (66mm)
6" (152mm)
2-1/2" (64mm)
3-1/8" (79mm)
3-1/8" (79mm)
19