Elan 83993 Mode D'emploi page 3

JUNCTION BOX INSTALL:
• Please contact a qualified licensed electrical contractor to ensure installation meets national
electrical code NFPA70. Junction boxes should be covered and wires entering or exiting the box
should be secured. Instructions below are for a typical install.
• Remove the knockout in the box cover (not included) and install a NM cable connector clamp
(not included).
• Pass the mirror jumper wire through the clamp and secure.
• Attach the mirror jumper cable's wires to the junction box supply wires follows:
- WHITE (NEUTRAL) MIRROR JUMPER WIRE TO THE WHITE SUPPLY WIRE.
- BLACK (LIVE) MIRROR JUMPER WIRE TO THE BLACK SUPPLY WIRE.
- GREEN OR BARE COPPER MIRROR JUMPER WIRE TO THE BARE COPPER
SUPPLY GROUND WIRE.
• Secure cover to junction box.
MOUNTING: MOUNTING:
• Use provided paper template to locate the desired mounting location for the mirror and to mark the
locations required for the wall anchors.
• Use a 15/64 inch drill bit to drill pilot holes at the locations marked in step 1 and insert the wall
anchors.
• Pass the screws through oval holes in the mounting brackets and screw into the wall anchors.
NOTE: Brackets should have the angled end facing up.
• Hang brackets on back of mirror onto the screws of mounting brackets that are attached to the wall.
WALL WALL
ANCHOR ANCHOR
15/64 15/64
INCH DRILL INCH DRILL
BIT (NOT BIT (NOT
SUPPLIED) SUPPLIED)
ANCHOR ANCHOR
MOUNTING MOUNTING
BRACKET BRACKET
WOOD WOOD
SCREW SCREW
PHILLIPS PHILLIPS
SCREWDRIVER SCREWDRIVER
(NOT SUPPLIED) (NOT SUPPLIED)
3