Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
WARNING
•
IMPORTANT: NEVER attempt any work without shutting off the electricity.
•
Go to the main fuse box, or circuit breaker, in your home. Place the main power switch in the
"OFF" position and unscrew the fuse(s), or switch "OFF" the circuit breaker switch(es), that control
the power to the fixture or room that you are working on.
•
Place the wall switch in the "OFF" position. If the fixture to be replaced has a switch or pull
chain, place those in the "OFF" position.
•
Do not touch hot LED.
•
The LED light output is strong enough to injure human eyes. Precautions must be taken to prevent
looking directly at the LEDs with unaided eyes for more than a few seconds.
•
WARNING: California Prop 65: This lighting fixture contains chemicals known to the state of
California to cause cancer, birth defects, and/or other reproductive harm. Wash hands after use.
CAUTION
•
Read and understand all instructions and illustrations completely before proceeding with assembly
and installation of this fixture.
•
If you have any doubts about how to install this lighting fixture, or if the fixture fails to operate
completely, please contact a qualified licensed electrical contractor.
•
All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts
out, or use any parts that are worn out or broken. Failure to obey this instruction could invalidate
the UL listing, C.S.A. certification, and/or ETL listing of this fixture.
•
This fixture is intended for installation in accordance with the National Electric Code (NEC) and all
local code specifications.
•
This fixture is for indoor use only.
•
Use ONLY the supplied LED driver to power fixture.
•
Driver cable is not intended for use through or concealed behind walls, floors, or ceilings.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated assembly time: 30 minutes to 1 hour
Tools Required for Assembly (not included): Phillips screwdriver, flathead screwdriver, wire strippers,
electrical tape, ladder, safety glasses.
BEFORE YOU BEGIN:
This fixture is designed to be mounted either where there is a junction box in the wall, or just a
Romex NM-Cable exiting the wall. Instructions for electrical connections for both installation methods
are as follows.
2
Publicité
Table des Matières
