Troubleshooting - Breville the Smoking Gun Pro CSM700 Manuel D'instructions

Mesh Filter specification:
No.20 US Sieve Size [Ø25.4mm (1 inch),
stainless steel 304].
Set Screw specification: M3 x 6mm SS303
Hex Key specification: 1.5mm AF

Troubleshooting

POSSIBLE PROBLEM EASY SOLUTION
Cannot attach fan.
Fan not starting.
Cannot attach barrel.
No smoke generated.
Not enough smoke.
Smoke is leaking around
the barrel.
•
Back out the small set screw to ensure it is not blocking the shaft hole.
•
Ensure the motor shaft hole in the fan is not blocked.
•
Check orientation of batteries.
•
Replace batteries.
•
Ensure the fan is assembled correctly with an approximate 1mm gap behind
the fan. See if it can rotate when the barrel is in place by poking it with
toothpick (or similar).
•
Ensure orientation is correct – large hole in the barrel should be facing
upwards to the side of the center line of the unit when the bayonet lugs are
initially engaged.
•
Ensure the fan is in the correct position – it should have a small gap (about
1mm) behind.
•
If the barrel is hard to rotate - add a small amount of food safe oil to the
surface of the O-ring.
•
Ensure mesh filter is not blocked.
•
Ensure the hose is not blocked or kinked.
•
Ensure the fan starts when the switch is rotated between MAX and MIN.
•
When using a closed container ensure there is an outlet for the air to escape.
•
Ensure wood chips are dry and small.
•
Increase fan speed to MAX.
•
Turn fan to MAX to increase burn rate.
•
Ensure the O–ring is in the correct position.
•
Ensure the O–ring is free of any damage.
WARNING
• Do not immerse the housing in liquid.
• Do not operate the unit without the barrel
in place.
• Resin may stain hands, handle parts
with caution.
Visit BrevilleCommercial.com to order more
wood chips and more mesh filters.
11