Ener-G+ HEA-215110 Guide D'utilisation page 3

2 X M6*50 screws
2 X M4*35 screws
2 X round washers
1 X cord holding plate
Place the heater and its components on a non-marking and non-scratching surface.
Have a Phillips screwdriver at hand (not supplied). Remove the Allen key Package
Read this manual before installation and use. Keep this manual in a convenient place for future use if needed.
Installation:
1. Put the heater upside down. Insert the AC power cord through the base cover (#3) and then through the base (#2).
2. Insert the base cover (#3) on the heater (#4). Insert the base (#2) into the base cover (#3). Put the two round
washers (#6) onto the base (#3). Insert the two M6*50 screws (#1). Screw on tight.
3. Pull on the AC power cord and insert it into the grooves on the base (#2). Put the square washer (#5) on the base
and then fix it with the two M4*35 screws (#5) to secure the AC power cord onto the base (#2) with a Phillips
screwdriver.
4. Turn the heater right side up.
REMEMBER: Portable electric heaters are designed for spot heating or as a supplementary heat source. They are not
intended to be the main source of heat during cold months.
Caution: If you must use an extension cord, the cord should be at least No. 14 AWG and rated for no less
than 1875 W.
You must always make sure that there is at least 1' 6" (50 cm) of empty space above the heater,
9" (25 cm) from the side and 5' (1.8 m) below the heater.
Remote control:
-Always purchase the correct size and grade of battery for the included remote control.
-Replace all batteries of a set at the same time.
2