Problem Solving; Specifications - GBC PUNCH G2 Manuel D'instructions Et D'utilisation

6. PROBLEM SOLVING

Problem
No power, won't punch
Punched holes not aligned with
the edge of the paper
Sheet jamming repeatedly at die
set area.
Insert Chip tray message on the
LCD interface.
Probable Cause
Power cord not attached to back
of machine or not properly
plugged into the wall.
Power On/Off Switch
activated.
Follow instructions on die set
labels to properly configure the
die for a specific sheet size.
Remove the die-set, inspect the
die throat to see if there is any
stuck paper chad.
Make sure the Chip tray is fully
inserted.

7. SPECIFICATIONS

Speed
Punch Sheet Size and
Edge
LEF- Long Edge Fed
not
SEF- Short Edge Fed
Tab Stock
Paper Stock
Clear Cover
Bypass mode stock and
sizes
Punch Capacity
Power Supply
Electrical
Safety Certification
Dimensions
Weight
Shipping Weight
Manufactured
PUNCH G2
Up to 136 sheets per minute
US Sizes
LTR LEF
LTR SEF
LTR SEF Double Punch
Statement LEF
Legal SEF
Ledger SEF
Ledger SEF Double Punch
ISO sizes
A4 LEF
A4 SEF
A4 SEF Double Punch
A5 LEF
A3 SEF
A3 SEF Double Punch
US Sizes
LTR, with 3,4,5,8 and 10 tabs
Statement, with 3 and 5 tabs
ISO Sizes
A4, with 5 and 10 tabs
A5, with 3 and 5 tabs
Plain: 75gsm - 300gsm
(20# bond to 110# cover)
Coated: 120gsm - 300gsm
(32# bond to 110# cover)
7mil
Paper sizes and stocks same as
printer
Single Sheet
115V, 60Hz, Single Phase
230V, 50Hz, Single Phase
Amps and 115V; 3.8A; 60Hz (or)
Frequency 230V; 1.9A; 50Hz
cULus
L: 775mm; W: 445mm; H: 1020mm
L: 30.5"; W: 17.5"; H: 40.2"
95 kg
210 lbs
123 kg
272 lbs.
Assembled in Taiwan
EN
9