Samsung RSH7ZNRS Mode D'emploi page 10

Reattaching the Fridge Door
1. Insert the lower hinge 1
hinge bracket .
2
2. Fit the hole in the corner of the fridge door
over the lower hinge .
4
3
4
3. Insert the upper hinge shaft
on the hinge 6 . Make sure the hinge is level
between the upper hinge hole
the top of the cabinet
8
screws and the ground screw
9
in a clock wise direction.
4. Place the front part of the upper hinge cover
on the front of the upper hinge
with the screw.
11
10_
setting up
back into the lower
1
2
3
into the hole
5
and the hole on
7
. Then, reattach hinge
by turning it
10
11
and reattach it
12
12
Reattaching the Water Supply Line
1
1. Insert the water line into the coupler
Reattaching the Water Supply Line
1. Water line must be fully inserted to the marked line
to prevent water leakage and water dripping from
the water dispenser.
Line
Coupler Coupler
2. Insert the 2 clips in the install pack and check that
each clip holds the line fi rmly.
clip A
(6.35mm)
Coupler Coupler WHITE WHITE
WHITE WHITE
Do not cut the water line. Gently separate it
from the coupler.
Reattaching the Front Leg Cover
Before attaching the cover, check water
connector for leakage.
Replace the front leg cover by turning the three
screws clockwise, as shown in the fi gure.
2 .
1
2
Line
Coupler Coupler
clip A
(6.35mm)
Coupler Coupler
GRAY GRAY GRAY GRAY