Maintenance And Service - Garland AMAZON 100 E Manuel D'instructions

English
This pump comes with a self pumping system. When
the pump is submerged and started, this system
expels all the air through the ventilation orifice. If the
water level is below this orifice, some water might also
come out through the orifice. This is normal.
6.4. RECOMMENDATIONS
Do not use this pump with mud, sandy water,
excessively dirty and murky water or water with high
levels of impurities and/or filaments. These elements
could cause the blockage of the pump as well as
wearing the machine a lot quicker.
The pump will lower its water outflow the higher the
impulsion hose is. Always try and lower as much as
possible. Check the graph of outflow/height in point
4.3.
Do not leave the pump in the workplace after finishing
your task as it could get stuck in the mud once the
water has been cleared.
Do not block the water exit. The pump must be placed
in such a way that water can outflow correctly.
If the bottom is very dirty, place a platform such as a
brick and place the pump on top thus reducing the
quantity of impurities that the pump will absorb.

7. MAINTENANCE AND SERVICE

The removal of the security elements, a poor
maintenance or the substitution of spares and
accessories by non original ones can all cause severe
corporal damages.
Always carry out all the maintenance work
with the machine unplugged from the
mains.
Unplug the machine always before carrying out any
work on the pump. Read the instruction manual before
carrying out any maintenance work.
7.1. MAINTENANCE AFTER WORK
Carry out the following maintenance work once
you finish your task to guarantee that the machine
functions correctly next time.
7.1.1. CLEANING
Attention! Always clean the machine after use.
Not cleaning the machine adequately will result
in damages to the machine and the machine will
work less. Wherever possible, clean the machine
immediately after working with it.
To clean, empty the water from the interior of the
pump, rinse with non salted water and allow to dry
before storing.
7.1.2. GENERAL CHECKS
Check the status of the cable searching for
possible signs of wearing out and possible
cuts.
24/88