ARENDO 303323 Manuel D'utilisation page 21

4. Assembly
① Press the motor shaft (2) as far as it goes into the base unit.
② Place the juice container (4) on the base unit (1).
③ Then insert the strainer (5).
④ Place the desired pressing cone on the motor shaft (2).
5. Usage
Take the appliance out of the package and remove all the packaging material.
Place it on a flat and firm surface.
• Connect the plug to a properly installed socket.
• Place the desired container under the spout of the juice container.
• Press the spout (3) downwards or upwards to open or close the spout.
• Cut the desired citrus fruit into two parts before squeezing them.
• Hold the citrus fruit with one hand and the squeezer with the other hand while
pushing down on the pressing cone with half the citrus fruit.
Note: The pressing cone starts to turn automatically. Do not press too hard on the
cone because the appliance stops if the pressure is too much.
• Before removing the container, press the spout upwards to close the outlet and
prevent the juice from flowing out.
• After usage, remove the power cord from the socket and then clean the
appliance.
Note: Ensure that you refrigerate the juice after extraction. Remember that the
juice should not be stored for more than one day. Do not keep the juice in metal
containers because the acid in the juice may affect the surface and impair the
taste.
English
21