Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product may vary slightly from what is illustrated.
1. Spray nozzle
2. Water-fill cover
3. Backlit LCD display
4. Steam ON/OFF button
5. Spray button
6. Surge-of-steam button
7. Comfort Grip
handle
®
8. 360-degree swivel cord
9. Non-skid heel rest
10. Water tank
11. AUTO CLEAN
button
®
12. Temperature control buttons
13. Soleplate
14. Change language button (not shown)
4
How to Use
This appliance is intended for household use only.
GETTING STARTED
• Please go to www.prodprotect.com/applica to register your warranty.
• Remove and save literature.
• If ironing dry, place appliance on its heel rest on a stable ironing board.
• Uncoil cord and plug into standard electrical outlet.
Important: For optimum performance, allow the iron to stand for 90 seconds until
the Standby
symbol in the bottom right of the LCD display changes to Ready
.
FILLING WATER TANK
1. With iron on flat surface with soleplate down, open water-fill cover.
2. Tilt the iron and using a clean measuring cup, pour water into opened chamber
until water reaches the MAX level mark on the side of the water tank. Do not
overfill.
Note: This iron can be filled with ordinary tap water; if your water is hard or soft,
you may want to use distilled water. Do not use water processed through a home
softening system.
3. Close the water-fill cover.
Note: If you need to add water while ironing, unplug the iron and follow the above
steps.
4. Plug the iron into an electrical outlet
•
The iron beeps.
•
The backlight illuminates and turns off.
•
The Standby
symbol remains on the LCD display.
5. Turn on the iron by pressing the (+) temperature control button, located to the left
of the LCD display.
•
The iron beeps.
•
The LCD backlight turns on.
•
The iron begins to heat up and the LCD displays the lowest heat setting.
SELECTING FABRIC TEMPERATURE
1. Read fabric labels to help determine fabric type to be ironed.
Tip: If unsure of fabric's fiber content, test a small area (on the inside seam or hem)
before proceeding to iron the entire garment or cloth.
2. Once you determine the fabric type, press the (+) and (-) fabric selector buttons
on either side of the LCD display to select the appropriate fabric setting. The
LCD display will light up and the fabric type will appear at the top with the
corresponding number for the setting below it to the left. There will be a flashing
arrow ▲ to show the iron is heating. When the iron is heated, the iron will
beep and the Standby
symbol will change to Ready
disappear.
3. Whenever the temperature setting is changed, the ▲ or ▼ symbols will appear
on the LCD to show that the iron is either heating up or cooling down to the newly
selected setting.
Important: Always stand the iron on its heel when powered on but not in use.
STEAM SELECTION
1. The steam symbol can be displayed by pressing the Steam ON/OFF button, which
is located just behind the LED display and in front of the steam and spray buttons.
and the arrow will
5
4
Publicité
Table des Matières
