Saivod DHX-10D Mode D'emploi page 91

NOTE
1. Do not remove the float from the water tank. The water full sensor will no longer be able
to detect the water level correctly without the float and water may leak from the water tank.
2. If the drainage tank is dirty, wash it with cold or lukewarm water. Do not use detergent,
scouring pads, chemically treated dust cloths, gasoline, benzene, thinner, or other solvents,
as these can scratch and damage the tank and cause water leakage
GB
3. When replacing the drainage tank, press the tank firmly into place with both hands. If
the tank is not positioned properly, the "TANK FULL" sensor will be activated, and the
dehumidifier will not operate.
Continuous Water Drainage
The unit features a continuous drainage port .Using a plastic pipe (with an inner diameter
of 10mm) inserts into drain hole (on intermediate plate), reach out from side of water tank,
install it in place, and arrange the drain pipe.
The water in the drainage tank can be continuously drained out from the continuous port
on the unit.
91