Samsung D154 Serie Manuel D'utilisation page 14

Setting up your dishwasher
STEP3. Connecting the hoses and powering
1. Remove the hose holder which is attached to the product and cut off part of the holder as shown in the
fi gure.
2. Discard the part you have just cut off and use only the part that is shown by the fi gure.
3. Fix it to the wall by fastening the 2 screws.
4. Insert the drain hose into the fi xed hose holder.
Install the drain hose so that it is placed within a range of 30 cm to 80 cm from the bottom.
5. Connect the drain hose to the drain outlet.
• Take care when you connect the drain hose that it does not move during a draining cycle.
• Confi rm that no parts of the drain hose, supply hose or power cord are bent or folded.
CAUTION
6. Open the door and remove all foam, paper packaging, and unnecessary parts.
7. Turn on the circuit breaker you turned off before you began the installation.
8. Open the water supply valve to supply water to the dishwasher.
9. Turn on the dishwasher, and then select and run a cycle.
Check if the power turns on correctly and if there is any water leakage while the dishwasher is
operating. If no errors occur while it is operating, turn off the dishwasher, and then go to No.5 of
above.
If an error has occurred, turn off the dishwasher, close the water supply valve, and then refer to the
user manual or contact a service center as referring to the contact list on the back cover.
Make sure to check for water leakage on both ends of the water supply line and drain hose
connector.
CAUTION
Test run
Make sure that you install your dishwasher correctly by running the Quick or Prewash cycle after
the installation is complete.
14_ Setting up your dishwasher
DD68-00093J-04_EN.indd 14 DD68-00093J-04_EN.indd 14
Max.
80 cm
Min.
30 cm
2013-06-18 2013-06-18 2:15:08 2:15:08