RAMSET T4 Serie Mode D'emploi page 5

DANGER
FAILURE TO FOLLOW
INSTRUCTIONS CAN
CAUSE INJURY TO THE
TOOL OPERATOR OR
TO BYSTANDERS.
• Use the tool only in well ventilated
areas.
• Always hold the tool at right angles to
the work surface.
• Never attempt to make a fastening
at an angle to the work surface.
• While the tool can be used in any
position (floor, wall or ceiling) it is
important to have both the nose of
the tool and support foot in contact
with the work surface to minimize
spall and make the best quality
fastenings.
• Do not put a fastener into the nose
of the tool until just before you intend
to make the fastening.
• Never place your hand or any other
body part over the fastener loading
end of the tool.
• Never carry the tool with your finger
on the trigger.
• Never leave the tool unattended or
allow anyone to operate it without
first being trained.
• Never engage in horseplay with
the tool.
• Always keep the tool pointed away
from yourself or others.
• Never operate the tool if explosive
or flammable materials are nearby.
• Keep the tool and supplies locked
up and out of the reach of children.
DANGER
SAFETY INSTRUCTIONS
Ceilings
The T4 tools may be
used in any position.
90°
Keep both the nose of the tool
and support foot in contact with
the work surface and hold tool
perpendicular to the work surface.
Keep tool locked up and
out of reach of children
SAFETY INSTRUCTIONS
Walls
Floors
5