Water Filter Bypass - Sub-Zero Classic Serie Guide D'installation

Masquer les pouces Voir aussi pour Classic Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
Completion
Reinstall the drain pan and verify it is in the proper position.
Install the kickplate using the magnets to attach it to the
brackets on the inside of each roller base. Refer to the
illustration below. The kickplate must be removable for
service. The floor cannot interfere with removal. Refer
to the label mounted on the kickplate support for height
clearance.
To turn power on to the unit, touch and hold
control panel.
Kickplate installation
18 | Sub-Zero Customer Care 800.222.7820

WATER FILTER BYPASS

If the water filtration system will not be used, it can be
placed in water filter bypass mode by removing the water
filter. Refer to the illustration below. Follow these steps to
remove the water filter:
1
Pull out on the bottom edge of the grille assembly and
tilt the grille frame upward.
on the
To remove the cartridge, rotate the cartridge counter-
2
clockwise one-quarter turn and pull out. Refer to the
illustration below.
Water filter location
WATER FILTER
WATER
FILTER
Water filter removal

Publicité

Table des Matières
loading

Table des Matières