Water Dispenser - Saba CB295WDIX/2 Mode D'emploi

To remove the ice cubes from the tray, put the tray under running
water for a while and then twist the tray slightly to loosen the ice
cubes�

WATER DISPENSER

The refrigerator includes a water dispenser which makes it easier
to fill your cup of water and have access to cold water instantly�
The water dispenser can hold 2 litres of water� To fill and use the
water dispenser:
1� The water tank is located inside the refrigerator door (see
GB
"DESCRIPTION OF THE DEVICE")�
2� Open the cover of water tank, slowly fill the water tank to
prevent any spills up to the maximum fill line (taking care not to
overfill)� Then close the cover of water tank�
3� The water will take time to cool� If you want to speed the process
up turn the temperature control up to 7 for 30 minutes� Ensure
the temperature control is turned back down to its normal
operating setting after 30 minutes�
38
ATTENTION
• Only use clean or boiled water that is cold and does not
container any impurity�
• Do not use hot water or any carbonated drink such as Cola,
Cider etc� (any fizzy drink)�
• Do not remove the water tank from the door to fill�
• The maximum fill must be lower than the tank cover as
indicted by the maximum fill line�
• If water is not dispensing, check the tank is properly located in
its holder�
• To remove the tank, make sure that it is empty�
• When using the water dispenser, some water may drip and
accumulate in the water tray at the bottom of the water
dispenser� Pull the water tray towards you and clean it when
necessary�
• Mount the seal to water tank per below picture�
GB
39