Terraillon TPRO4300 Notice D'utilisation page 9

2. Insert the pillar into the hole at the base, while holding
the pothook with your hand.
Important: Ensure pillar is completely seated onto
base otherwise the scale will not operate correctly.
When the red indicator line (located on the pillar)
meets the edge of the collar on the base, the pillar
will be properly seated in the base of the scale.
3. Use screw driver as well as your hand to hook the
pothook into the hole of the long arm connecting plate.
The steel screw on the base (which will be removed
in the next step) can be adjusted inward to move the
long arm connecting plate up towards the pothook
and make the connection between the two points easier.
4. Using Allen key to remove the pre-set assembly
steel screw out from the small hole (located in the bottom
part of the base) to release long arm connecting
plate down to its place.
5. Using screw driver to fix the pillar to the base by
screwing in tightly the 2 pcs of screws at the left and
right side of the pillar.
8
4
MECHANICAL MEDICAL SCALE
Pre-set assembly
steel screw
Pothook
Long arm
connecting plate
Pothook
Long arm
connecting plate
Screws