Outwell H-4000 Mode D'emploi page 3

UK: INSTRUCTION MANUAL
2. OPERATION
• WARNING: Use only outdoors
• Do not misuse the appliance or use it for other purposes than what it is intended for.
• Do not modify the appliance.
• Never leave the appliance unattended when lit.
• Handle the appliance with care. Make sure not to drop it.
WARNING: Do not move the appliance during use.
• Use gloves and sturdy long barbecue tools when cooking on the gas grill.
• Hot fat may drip out at the bottom of the fire bowl. Do not light your gas grill on a surface that may
be damaged by the hot fat or heat generated by the gas grill.
• Do not use an appliance which is leaking, damaged or which does not operate properly.
• WARNING: Accessible parts may be very hot. Keep young children away.
• WARNING: Turn off the gas supply at the gas cylinder after use
• Always disconnect the gas cylinder from the appliance when not in use.
• Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any
other appliance.
• Any LPG cylinder not connected for use should not be stored in the vicinity of this
or any other appliance.
• The appliance shall be operated on a horizontal surface
- non likely to impair its operation
- free from dry grass, sand etc.
- do not place it on any combustible materials.
• The appliance shall be used away from flammable materials during use with minimum distances as
shown below.
100 cm
100 cm
Connecting your gas grill to a gas cylinder
Please see TECHNICAL DATA table for information regarding regulator and hose. Only use a regulator
complying with EN16129 and a hose complying with EN16436. The length of the hose shall not
exceed 150 cm. Both regulator and hose must also comply with national regulations. Replace the hose
according to national regulations. Avoid twisting the hose.
Always read the manual regarding the regulator and hose.
Never leave the regulator attached to the gas cylinder if disconnected from the gas hose.
All manuals and user guides at all-guides.com
150 cm
100 cm
100 cm
4
UK: INSTRUCTION MANUAL
1. To be able to use your gas grill you will need to purchase an LPG gas cylinder, a regulator and a hose.
The type of gas can be butane or propane or a mixture. The regulator needs to fit the chosen gas
cylinder and deliver a supply pressure of 28-30mbar if the gas is butane. 30 or 37 mbar if the gas is
propane. The hose needs to fit the regulator as well as the gas grill. The gas grill can be used with
either ¼" LH thread, 8mm ID or 10/11mm ID.
a) If your hose has an internal diameter of 8 mm, push the hose over the first ribbed half of the
removable hose stud. Thread the hose and stud onto the gas inlet connection.
b) If your hose has an internal diameter of 10/11 mm, push the hose all the way over the ripped part
of the removable hose stud. Thread the hose and stud onto the gas inlet connection.
c) If your hose is equipped with a ¼" left hand thread, thread the hose directly onto the gas inlet
connection.
The hose should be threaded hand tight plus a ¼ of a turn.
a) b)
2. Once you have successfully connected your gas grill to a gas cylinder, position the gas cylinder at the
side of your gas grill. Keep in mind that the cylinder must be kept away from heat and in a safe and
upright position.
3. Attach the regulator to the gas cylinder tap correctly (refer to the instruction manual provided with
the regulator).
4. Always check for leaks at all joints using soapy water.
NEVER USE A NAKED FLAME TO CHECK FOR LEAKS.
Lighting Your Gas Grill
1. Open the lid. CAUTION: the lid must always be open when lighting the burner!
2. Close the tap (9) by turning it clockwise (in direction of the arrow next to the word 'CLOSED') until it
stops (do not over tighten).
3. Open the regulator on the gas cylinder.
4. Turn the tap (9) a ¼ of a turn (this will release the gas into the burner) and at the same time press the
piezo ignitor (4).
5. If the burner does not light after 4-5 attempts, close the tap and wait 5 minutes, then repeat steps 3
and 4.
6. Use the tap to adjust the heat.
For your safety – if you smell gas
• If there is a leak on your appliance (smell of gas), turn off the gas supply and take it outside
immediately into a well-ventilated flame free location where the leak may be detected and stopped.
If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks using a flame,
use soapy water.
• If odour persists, stop using the appliance immediately and contact your dealer or gas supplier.
c)
5