Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
FEATUrES
• Two charging ports can charge two batteries at once. Batteries can be
different chemistries, capacities and cell counts
• 50W charge power output for Ni-MH (4–8C) or Li-Po (1–6S) batteries
• High-visibility, simplified user interface
• Two 4-digit LED indicators to display charge current, battery type,
charge capacity, cell voltages and error codes
• Select charge current from 0.1A to 6.0A with two independent charge
current dials
• Three LEDs per channel (red, yellow and green) to indicate charging
status
• Short-circuit, over-current, reverse polarity, low input voltage and over-
temperature protection
• Insulated, color coded, banana jack, power output terminals
(Red = Positive (+), Black = Negative (–))
• Internal cooling fan with grill cover
• Meets IP33CW, IK07 environmental specs
• Rugged industrial plastic case
SPECIFICATIoNS
AC Input Voltage 100–240V AC (50–60Hz)
Battery NiMH (4-8C) / LiPo (1-6S)
Charge Current 0.1A to 6.0A per channel (in 0.1A
increments/50W maximum per channel)
Operating Temperature 0º C to + 50º C
Charging Mode Ni-MH: Peak; Li-Po: Constant Current (CC)/
Constant Voltage (CV)
Capacity 2,000 to 5,000 mAh
gETTINg STArTED
When using an External AC Power Source:
CAuTION: Always power ON the charger before connecting a
battery, or damage to the charger and the battery can result.
CAuTION: Before charging, always ensure you have chosen the
correct battery chemistry type for the battery you are charging.
Connect the AC power cord to the AC Power Input Port.
1.
2.
Connect the AC power cord to the AC power source.
3.
Power ON the charger with the Power Switch.
4.
When the charger is powered ON, all 6 LEDs will blink 5 times with
5 beeps and all 4-Digit LED Indicators will display 8888. After 5
seconds, all the LEDs will glow solid and the 4-Digit LED Indicator
will display the current battery type selected (nI, LIPO or FASt) for 2
seconds, then display the charge current selected by the Charge
Current Dial.
5.
Select the charging settings.
6.
Connect the battery to the charger.
7.
Start battery charging.
4
Publicité
Table des Matières
