LDI Spaces Safco1872 Instructions De Montage page 2

1
Work on a smooth, clean surface. Place the A Top Panel face
down with the holes up. Position one C Side Panel on one
end of the Top Panel with the flanges toward the center of the
unit. Fasten the Side Panel to the Top Panel with two L Screws
Attach the B Front
Leg Frame to the
Side Panel using
L Screws. Attach
the other C Side
Panel in the same
manner.
3
Slide the F Bottom Shelf into the unit between the Side
Panels, with the flanges toward the bottom end of the unit.
Slide the flanges of the shelf into the lower flanges on the Side
Panels and Back
Panel. Fasten the
Bottom Shelf to
each Side Panel
using two L
Screws per side.
5
Slide the four I Plastic Bushings onto the pins on each side
of the Front Leg Frame. Loosely fasten the H Door Handles
to the J , K Door Panels with one L screw in each center hole.
PINS
I
7
Use a hammer or mallet to tap one M Caster Insert into each
of the four legs. Push the stems of the N Casters without
Brakes into the caster inserts in the Rear Legs. Push the O
Casters with Brakes into the inserts in the Front Legs.
N
M
REAR
LEG
1872-37: 2 of 2; Rev. 3: 05/05
B
C
L
A
H
K
J
Safco Products Company, New Hope, MN 55428
2
Slide the D Back Panel into position between the Side Panels
as shown in the inset. Keep the Back Panel inside the flanges
on the Side Panels. Fasten the Side Panel and Back Panel to
each E Rear Leg using three L Screws from the interior.
E
4
Slide the G Inner Shelf into the unit between the Side Panels,
with the flanges toward the bottom end of the unit. Slide the
flanges of the shelf into the shelf holders on the Side Panels
and Back Panel.
F
L
6
Position one Door Panel with the magnetic insert upward as
shown. Slide bottom hole in the door onto one Plastic Bush-
ing; tilt the Door Handle and slide it onto the upper Bushing.
Fasten the handle to the door using two more Screws. Repeat
L
for the other door.
8
Carefully turn the completed unit upright. To align the doors,
slightly loosen the screws in the handle, adjust, and re-tighten
the screws.
O
M
FRONT
LEG
D
L
L
G
SHELF
HOLDER
MAGNET