AGA Marvel ML15CR Instructions D'installation, D'utilisation Et D'entretien page 14

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
NOTE
If your ice machine has a door lock proceed to Step 7.
If your ice machine does not have a door lock proceed
to Step 9.
Step 7: Mark and drill lock hole.
Locate and mark with a pencil the location of the lock hole
on the overlay panel, this is the hole in the top corner of
the handle side of the door. Remove the clamp and re-
move the overlay panel from the door. On the backside
of the panel where you marked the lock location drill a
⁄ " (20.5mm) diameter counter bore
13
16
into the overlay panel. Drill a
through the overlay panel centered on the counter bore be-
ing careful not to splinter the wood on the face side of the
panel. (See Figure 12).
Step 8: Assemble the lock parts
Two (2) lock extensions are supplied with the lock. Use
the longer extension for a
shorter one for a ⁄ " thick panel. Assemble the lock exten-
5
8
sion, cam stop washer, spring washer, and set screw to the
lock as shown in Figure 11 and 12.
Install this assembly into the overlay panel and secure with
the retaining nut using a 15mm socket. Make sure the key
slot in the lock is vertical.
1.234" (31.3mm)
.991" (25.2mm)
⁄ " (11.0mm) deep
7
16
⁄ " (12.0mm) diameter hole
15
32
⁄ " thick overlay panel and the
3
4
Figure 11
BRASS EXTENSION
SPRING WASHER
NUT
LOCK
1/2 HOLE
13/16 COUNTER
BORE 7/16 DEEP
3/4 INCH
WOOD PANEL
Step 9: Secure overlay panel to the door.
With the #10 wood screws provided, fasten the overlay
panel to the door. (See Figure 14).
14
CAM
PHILLIPS SCREW
INNER
DOOR
SECTION A-A
SCALE 1 : 1
Figure 12