Assembly; Functions; Before First Use - Sage Smoking Gun BSM600 Guide Rapide

Assembly

1. Place the mesh filter in the top of the burn
chamber and press down with a finger to
seat it into the bottom of the burn chamber.
2. Place the burn chamber into the barrel.
Push down until the spring around the burn
chamber provides a small click sensation.
3. Press the larger plastic end on the silicone hose
firmly into the round hole on the front of the barrel.
BATTERIES
Use 4 x AA (1.5V alkaline) batteries only.
(No rechargeable batteries)
1. Remove battery cover from underside of unit
by sliding clip towards rear and rotating outwards.
2. Insert batteries into cavity with orientation
to match the outer face of the battery cover.
3. Replace battery cover and press to snap
into place.
6
CLICK

Functions

BEFORE FIRST USE

Wipe the burn chamber and mesh filter with
a damp cloth.
OPERATION
1. Place a small amount of wood chips (or desired
smoking materials) into the burn chamber.
NOTE
Do not overfill the burn chamber. The wood
chips should just cover the mesh filter area
with a thin layer.
2. Press down the power switch located on
the rear of the main unit, to activate the fan
at high speed. This position is designated
by 2 lines = on the switch.
–
Low Speed
To smoulder the
wood chips and
generate smoke.
3. Use a handheld lighter or match to apply
a flame to the top surface of the wood chips.
Move the flame around to ignite the entire
exposed surface. For best results make sure
the burning area is evenly distributed or centred.
WARNING
Maintain the presence of the lighter for
a period of time sufficient to start ignition only.
Excessive heat may cause damage to the unit.
4. Once the smoke is seen exiting the end of the
hose, depress the top of the switch to maintain
the fan on low speed (designated by 1 line –).
Allow the wood chips to smoulder and direct
the smoke to where required.
5. When sufficient smoke has been generated
or wood chips are extinguished, return the
switch the central position to turn the fan off
(designated by a circle O).
=
O
High Speed
Off
For greater airflow
to assist in initially
igniting wood chips.