Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
LED Wall Pack & Floodlight
E-WF Series
Using 1/2" Slip Fitter:
4.
Splice the knuckle power leads to the branch circuit power
leads and push the splices inside the threaded hole.
5.
Screw the knuckle into the threaded hole, rotate to the
desired angle, then tighten the mounting nut.
6.
Loosen the Allen head screw in the side of the knuckle hinge
and adjust to the desired angle, then retighten
Using Trunnion:
4.
Mount the trunnion in place using the bolt holes provided.
5.
Route the fixture waterproof cable exiting the wiring box
to the power supply using a waterproof connector. Splice
the fixture power leads to the branch circuit leads -- black
to black (hot), white to white (neutral), and green to green
(ground).
To aim fixture:
6.
Remove #10-24 positioning screw.
7.
Loosen both 5/16-18 hex head bolts on sides of yoke.
8.
Rotate yoke to desired angle. Line up inner and outer yoke
positioning holes.
9.
Insert #10-24 screw into matching holes of inner and outer
yokes, and tighten.
10. Retighten 5/16-18 hex head bolts.
www.e-conolight.com
|
Document:
LPN00290X0001A1_A
Created By:
TMT
888.243.9445
|
FAX: 262.504.5409
Date
2015-5-29
DCR#
2015-166
Publicité
